Entering the "Dump Headers" command ("DH <#>") will printout selected trace headers (see the "SH" command) for each trace in record #. If no # is given, then it will printout the trace headers for the next record in sequence. Once this is done, then each time a blank command is entered it will printout the headers from the next record or if you enter just a # by itself, it will printout the headers from the specified record. You can use the "ST" command to select the traces to have printed out. The example shown below used "st 1 10" to select the traces to dump.

dh 24

                       --- Header Dump ---

               Rec #   Trc #      LinInd      StaCor      RecInd
 Trc    1864:      24       1           0         -26         232
 Trc    1865:      24       2           0         -27         233
 Trc    1866:      24       3           0         -27         234
 Trc    1867:      24       4           0         -26         235
 Trc    1868:      24       5           0         -24         236
 Trc    1869:      24       6           0         -25         237
 Trc    1870:      24       7           0         -22         238
 Trc    1871:      24       8           0         -23         239
 Trc    1872:      24       9           0         -25         240
 Trc    1873:      24      10           0         -25         241